COMPANY HEADER
Request Information
CPF-T1 strip heaters are made of two offset bolt type terminals at one end.
Unit of Measure

Specifications

Brands

 N/A WATTCO™

Sheath Material

 N/A Aluminized Steel

Maximum Sheath Temperature

 N/A 1000 ºF

Heater Type

 N/A CPF

Terminal Design

 N/A Terminals at One End

Dimension C

 N/A 3 3/4 in95 mm

Power

 N/A 175 W

Power Density

 N/A 11.7 W/in²1.8 W/cm²

Voltage

 N/A 120 V

Power Density Type

 N/A Low

Heater Dimensions

Dimension A

 N/A 8 in203 mm

Application

Application

 N/A Free or forced air applications Duct heating Space heaters Drying ovens Incubators Food warmers Shrinking tunnels Air heating Load bank resistors Heat curing Dehumidifiers Ink drying Moisture protection Process welding Stress relieving ovens

Note

Note

 N/A
  • Standard strip heaters ratings: 120 V.
  • Heaters with 287 V are also available.
  • You can also use the strip heaters with lower voltages.
  • You can also use higher voltages with some strip heaters.
  • For higher temperatures, use stainless steel heaters.
  • Use additional insulators when voltage to ground is over 300 V.
  • Fin Dimensions
    • 0.022" thick cadmium plated steel with a nominal four fins per inch
    • Approximately 2" x 1 3/8"
When Ordering, Please Specify: Quantity, catalogue number, voltage, phase, wattage, and extra features.